Panasonic SC-HT1500 Operating Instructions Manual

STEP
Supplied Accessories
Make sure you have all
the indicated components
before assembly, setup,
and connection.
Preparation
≥ To prevent damage or scratches, lay a soft cloth and perform assembly on it.
≥ For assembly, use a Phillips-head screwdriver.
1
Attach the pipe to the large base.
1 Thread the speaker cable through the base.
Lessen excess speaker cable.
Cable
Groove
2 Insert the pipe.
Insert the pipe while slightly
pulling on the speaker cable.
1
2
Attach the stand to the front speaker.
≥There is no difference between the right and left speakers and stands.
≥Using the polyfoam and packaging cover included with this unit may be
convenient.
1 Remove the mounting plate screw, and remove plate B.
3
Speaker
Packaging cover
1
Front speaker assembly
∑ Front speaker units
Thread the speaker
cable through here.
Hole for screw
2
Mounting plate screw
1
2
Polyfoam
Plate B
∑ Pipes ∑ Large bases
3
Secure the pipe to the base.
Ensure the screws are securely fastened.
Rear side of base
The supplied stands are specially designed for
attachment to Panasonic SB-FS1500 front speakers.
Only use as indicated in this setup.
2 Place the pipe on plate A and attach plate B.
Rotate the pipe so that the flat side is facing away from the back of the
speaker.
3 Secure the plate with the same screw removed in
procedure 1 .
2
∑ Washer screws
Cable
Washer screw
Plate B
Plate A
Fit the offset into the slot
and slide the plate B into the
locked position.
Plate B
Offset
Slot
Align the surface of
plate B so that it is even
with the pipe surface.
Plate B
Pipe
Plate A