Table of Contents
Advertisement
Front speaker assembly
Preparation
For assembly, use a Phillips-head screwdriver.
Make sure you have all the indicated components before starting assembly, positioning, and connection.
There is no difference between the right and left speakers and stands.
For optional wall mount, refer to back cover.
Included parts to be used
2 Front speakers
2 Stands
(with cable)
1
Attach the speaker to the stand.
Place the polyfoam underneath the speaker for stability while attaching the speaker to the stand.
1
Feed the speaker cable (the shorter part) into the
bottom of the speaker and through the slot at the rear.
2
While pulling the speaker cable up through the slot,
slide the speaker stand into the bottom of the speaker.
Speaker
2
Attach the stand to the base.
1
Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do
not crease), pass the folded portion through the hole,
and then pull the rest of the cable through the base.
2 Bases
6 Screws
Cable
Stand
1
2
Polyfoam
Cable
Rounded side
Large hole
Base
2 Sliders
Thread the cable through the middle hole of the slider and
fasten with the two screws.
Slider
2
Insert the stand into the base
while gently pulling on the end
of the cable.
2
The speaker height
can be adjusted.
)
1
Min: 110 cm (43
/
4
)
5
Max: 135 cm (53
/
32
Cable
Screws
Tighten securely.
Cable
Advertisement
Table of Contents
