Initiating A Cold Start; Cpu Board - Emerson FloBoss S600 Instruction Manual

S600 Instruction Manual

7.3.1 Initiating a Cold Start

Unpowered Cold
Caution
Powered Cold
7-2
start builds a new metering database, using the configuration data
stored in the S600's Flash memory.
: You must perform a cold start if you update or otherwise change
Note
the firmware.
You initiate a cold start using either of two methods:
Unpowered.
Powered with operating S600.
If the S600 is not powered up, you may set bit link LK13 on the P152
CPU board to the closed (cold start) position and then apply power to
Start
the S600. This causes the Startup menu to display.
Exercise caution if you set the bit link (jumper). When you set the cold
start jumper, remember that the S600 also uses this setting if it self-
starts for any reason, such as a low-voltage shutdown or recovery
from a malfunction. Remove the cold start jumper setting when you do
not need it. Otherwise, an unplanned restart could result in lost data.
Select the COLD START option from the Startup menu (see
1.
Figure 7-1).
Press 1 (to keep) or 2 (to reset) the totals.
2.
Press 1 to confirm the selection. The S600 displays the message
3.
CONFIGURING – PLEASE WAIT
The S600 builds a new database using the configuration files held
in Flash memory. When completed, the S600 Main menu displays.
If the S600 is currently running, you must first set the run mode to
Cold Start.
Start
: The key sequence you use to access the System Status page may
Note
vary, based on the displays for your application.
From the S600 Main menu, select the SYSTEM SETTINGS
1.
option.
Select the SYSTEM STATUS sub-menu.
2.
Press CHNG.
3.
Key in your security code when the
4.
displays.
Press 1 to select the Cold Start option, and press 1 again to
5.
confirm the selection. The S600 displays a
– PLEASE WAIT
The S600 now performs a reset, which concludes when the Startup
menu appears.
.
message.
Startup
prompt
Enter Code
SYSTEM RESTARTING
Revised Jan-07