Cpu On-Board Connectors; Cpu Bit Links (Jumpers) - Emerson FloBoss S600 Instruction Manual

3.4

CPU On-Board Connectors

Table 3-8. Miscellaneous Device Connectors for the P152 CPU Module
Socket
3.5

CPU Bit Links (Jumpers)

Jumper (Link)
LK1 & LK2
CPU & RADISYS
LK3
LK4
LK5
LK6
LK7
LK8
LK9
LK10
LK11
LK12
LK13
LK14
Revised Jan-07
Table 3-8 shows the miscellaneous device connectors provided on the
P152 CPU module. This information is for identification purposes
only. Do not modify these connections unless told to do so by the
factory.
J1 DIN Backplane Connector
J2 CPU cooling fan molex (12 VDC)
J3 PC/104 expansion bus (16- bit)
J4 Additional plug-in battery molex 3.6 V dc
J5 IDE Hard disk pin header
J6 Altera serial programming pin header (factory use only)
J7 Keyboard and mouse pin header
J8 Security bit link (Off = Level 1 Security Disabled)
J9 Optional communications LED backplate pin header
Table 3-9 shows the CPU bit links (or "jumpers"). This information is
for identification purposes only. Do not modify these settings, unless
told to do so by the factory.
: The position values shown in boldface are the default
Note
configuration settings, which may not apply to your specific
configuration.
Table 3-9. CPU Bit Links
Position
Not Used
ON/OFF Voltage Selection (On = 5 V, Off = 3.3 V)
ON/OFF Internal Real Time Clock enable
ON/OFF Internal keyboard & mouse disable
ON/OFF 8 bit (Off) or 16 bit (On) BIOS
7 channel (On) or 2 channel (Off) DMA operation
ON/OFF
All interrupts available via MUX (Multiplex)
ON/OFF
ON/OFF EIDE parity (Off) or DRAM (On) supported
CS_USR1# (On) or Refresh (Off) supported
ON/OFF
COM1, COM2 supported: data & RTS/CTS only
ON/OFF
COMCLK enable
ON/OFF
ON/OFF Cold Start forced on power up
ON/OFF BIOS Monitor start enable
Description
Description
CPU
S600 Instruction Manual
3-9