Table of Contents
Advertisement
S600 Instruction Manual
Caution
2-4
Figure 2-3. Lifted Front Panel
Disconnect the ribbon cable from the back of the front panel at the
4.
blue connector (refer to Figure 2-4). Observe the orientation of the
connector with its mating keyway. You must correctly re-insert the
ribbon cable at the end of the installation process.
Do not remove the ribbon cable from the S600 housing entrance. This
might damage the S600.
Figure 2-4. Remove Connector
Remove the top and bottom bosses from the unit housing, using a
5.
5.5 mm (5 BA) hex wrench.
Installation
Disconnect
Here
Revised Jan-07
- Quick Links:
- Analogue Inputs (Anin)
Hide quick links:
Advertisement
Table of Contents
