Installing The Panel-Mounted Unit - Emerson FloBoss S600 Instruction Manual

Part
Display Keypad Molding
Case
Panel Cutout
Pitch Between Cases
Max Panel Thickness
Access

2.4.3 Installing the Panel-Mounted Unit

Revised Jan-07
Table 2-1. Mounting Dimensions
85 mm (3.35") width x 269 mm (10.59") height x 28 mm (1.10") deep
84.5 mm (3.327") width x 270 mm (10.63") height x 303.8 mm (11.94")
deep
66 mm (2.6") width x 150 mm (5.9") height
110 mm (4.33") giving 25 mm (0.98") air gap
10 mm (0.39")
Allow 300 mm (11.81") clearance directly behind case for maintenance
Figure 2-5. Panel Mount Dimensions
After removing the front panel, install the panel-mounted unit:
Keeping environmental considerations in mind, construct the
1.
framework of the cubicle to support the operating panel.
: A standard 483 mm (19 in) rack that is 311 mm (12.25 in)
Note
high can accommodate up to four S600s with the rear of the case
supported.
Refer to Figure 2-6 and Table 2-1 for position details for two 7 mm
2.
(0.276 in) holes and a cutout. The panel cutout should be
rectangular for each S600. Allow a tolerance of ± 3 mm (0.12 in)
on each axis.
Installation
S600 Instruction Manual
Dimensions
2-5