Analogue Outputs (Dac); Analogue Output Schematic; Function - Emerson FloBoss S600 Instruction Manual

4.1.2 Analogue Outputs (DAC)

Revised Jan-07
Table 4-1. ANIN Pin Connections for SKT-A
Pin
8
21
9
22
10
20
11
24
12
25
13
23
Table 4- 2. ANIN Pin Connections for SKT-B
Pin
8
7
20
The S600 supports four analogue outputs (D/A Converter). Each D/A
Converter channel is fully floating and provides its own floating
supply. Loads of up to a 650-ohm loop impedance can be connected
directly. The unit can be used in either source or sink configuration.
Refer to Figures 4-6, 4-7, and 4-8.
The D/A Converter output channels use the connector labeled SKT-A,
which is located on the backplate of the P144 board. Refer to Table 4-3
for the D/A Converter output pin connections on the back of the I/O
card.
Figure 4-6. Analogue Output Schematic (S600-Powered)

Function

ANIN-CH1
ANIN-CH2
ANIN-CH3
ANIN-CH4
ANIN-CH5
RETURN CH1-5
ANIN-CH6
ANIN-CH7
ANIN-CH8
ANIN-CH9
ANIN-CH10
RETURN CH6-10
Function
ANIN-CH11 (current)
ANIN-CH12 (current)
GND
I/O
S600 Instruction Manual
4-5