Service The Parksense Rear Park Assist System - Jeep Gand Sherokee 2016 Owner's Manual

232 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
The ParkSense switch LED will be ON when ParkSense is
disabled or requires service. The ParkSense switch LED
will be OFF when the system is enabled. If the ParkSense
switch is pushed, and the system requires service, the
ParkSense switch LED will blink momentarily, and then
the LED will be ON.

Service The ParkSense Rear Park Assist System

During vehicle start up, when the ParkSense Rear Park
Assist System has detected a faulted condition, the
instrument cluster will actuate a single chime, once per
ignition cycle, and it will display the "PARKSENSE
UNAVAILABLE WIPE REAR SENSORS" or the
"PARKSENSE UNAVAILABLE SERVICE REQUIRED"
message. Refer to "Driver Information Display (DID)" for
further information. When the gear selector is moved to
REVERSE and the system has detected a faulted condi-
tion, the DID will display the PARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORS or PARKSENSE UN-
AVAILABLE SERVICE REQUIRED message for as long
as the vehicle is in REVERSE. Under this condition,
ParkSense will not operate.
If "PARKSENSE UNAVAILABLE WIPE REAR SEN-
SORS" appears in the Driver Information Display (DID)
make sure the outer surface and the underside of the rear
fascia/bumper is clean and clear of snow, ice, mud, dirt
or other obstruction and then cycle the ignition. If the
message continues to appear, see an authorized dealer.
If "PARKSENSE UNAVAILABLE SERVICE REQUIRED"
appears in the DID, see an authorized dealer.