Jeep Gand Sherokee 2016 Owner's Manual page 383

Table of Contents

Advertisement

display along with a caution note to "check entire sur-
roundings" across the top of the screen. After five sec-
onds, this note will disappear. To change the mode status,
press the "ParkView Backup Camera Active Guidelines"
button on the touchscreen, until a check-mark appears
next to setting, indicating that the setting had been
selected.
• ParkView Backup Camera Delay
When the vehicle is shifted out of REVERSE (with camera
delay turned OFF), the rear camera mode is exited and
the navigation or audio screen appears again. When the
vehicle is shifted out of REVERSE (with camera delay
turned ON), the rear view image with dynamic grid lines
will be displayed for up to 10 seconds after shifting out of
"REVERSE" unless the forward vehicle speed exceeds
8 mph (12 km/h), the transmission is shifted into
"PARK" or the ignition is switched to the OFF position.
UNDERSTANDING YOUR INSTRUMENT PANEL 381
To set the ParkView Backup Camera Delay press the
"Controls" button on the touchscreen, the "settings"
button on the touchscreen, then the "Safety & Driving
Assistance" button on the touchscreen. Press the
"Parkview Backup camera Delay" button on the touch-
screen to turn the ParkView Delay ON or OFF.
• Rain Sensing Auto Wipers
When this feature is selected, the system will automati-
cally activate the windshield wipers if it senses moisture
on the windshield. To make your selection, press the
"Rain Sensing" button on the touchscreen, until a check-
mark appears next to setting, indicating that the setting
had been selected.
• Hill Start Assist — If Equipped
When this feature is selected, the Hill Start Assist (HSA)
system is active. Refer to "Electronic Brake Control
System" in "Starting And Operating" for system function
4

Advertisement

Table of Contents
loading

Table of Contents