Programming The Memory Feature; Linking And Unlinking The Remote Keyless Entry Key Fob To Memory - Jeep Gand Sherokee 2016 Owner's Manual

164 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Programming The Memory Feature

NOTE: To create a new memory profile, perform the
following:
1. Cycle the vehicles ignition to the ON/RUN position
(Do not start the engine).
2. Adjust all memory profile settings to desired prefer-
ences (i.e., seat, side mirror, power tilt and telescopic
steering column [if equipped], and radio station pre-
sets).
3. Push and release the S (Set) button on the memory
switch.
4. Within five seconds, push and release either of the
memory buttons (1) or (2). The Driver Information
Display (DID) will display which memory position
has been set.
NOTE:
• Memory profiles can be set without the vehicle in
PARK, but the vehicle must be in PARK to recall a
memory profile.
• To set a memory profile to your RKE Key Fob, refer to
"Linking And Unlinking The Remote Keyless Entry
Key Fob To Memory" in this section.
Linking And Unlinking The Remote Keyless Entry
Key Fob To Memory
Your RKE Key Fobs can be programmed to recall one of
two pre-programmed memory profiles by pushing the
UNLOCK button on the RKE Key Fob.
NOTE: Before programming your RKE Key Fobs you
must select the "Memory Linked To FOB" feature
through the Uconnect system screen. Refer to "Uconnect
Settings " in "Understanding Your Instrument Panel" for
further information.