Sunroof Maintenance; Ignition Off Operation; Relearn Procedure - Jeep Gand Sherokee 2016 Owner's Manual

266 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Sunroof Maintenance

Use only a nonabrasive cleaner and a soft cloth to clean
the glass panel.

Ignition Off Operation

NOTE:
• The power sunroof switch can remain active in Acces-
sory Delay for up to approximately ten minutes after
the vehicles ignition is placed to the Off position.
Opening either front door will cancel this feature.
• This feature is programmable using the Uconnect
System. Refer to "Uconnect Settings" in "Understand-
ing Your Instrument Panel" for further information.

Relearn Procedure

For vehicles equipped with a single-pane sunroof, there
is a relearn procedure that allows you to calibrate the
sunroof when the "Auto Up" feature stops working. To
reset the sunroof, follow these steps:
1. Set the ignition to the ACC ON/RUN position.
2. Ensure that the sunroof is in the Fully Closed position.
3. Push and hold the Close switch. The sunroof will hit
the hard stop and move to the Vent position after 10
seconds.
4. Release the Close switch, then push and hold the
Close switch again within 5 seconds to begin the
teaching process. The sunroof will complete one full
cycle and return to the Fully Closed position.