Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System - Jeep Compass 2018 Owner's Manual

Hide thumbs Also See for Compass 2018:
Table of Contents

Advertisement

Rear Distance
Greater than
(in/cm)
79 inches
(200 cm)
Arcs — Left
None
Arcs — Center
None
Arcs — Right
None
Audible Alert
None
Chime
Radio Volume
No
Reduced
NOTE:
ParkSense will reduce the volume of the radio, if
on, when the system is sounding an audio tone.

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
ParkSense Switch
174
WARNING ALERTS
79-59 inches
59-47 inches
(200-150 cm)
(150-120 cm)
None
None
6th Solid
5th Solid
None
None
Audible chime increases as the objects get close to the vehicle.
Yes
Yes
When the ParkSense switch is pushed to dis-
able the system, the instrument cluster display
will show the "PARKSENSE OFF" message for
approximately five seconds. Refer to "Instru-
ment Cluster Display" in "Getting To Know Your
Instrument Panel" for further information. When
the gear selector is moved to REVERSE and the
system is disabled, the instrument cluster dis-
play will show the "PARKSENSE OFF" message
for as long as the vehicle is in REVERSE.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed, and requires service, the ParkSense
switch LED will blink momentarily, and then the
LED will be on.
47-39 inches
39-25 inches
(120-100 cm)
(100-65 cm)
None
None
4th Solid
3rd Flashing
None
None
Yes
Yes
Service The ParkSense Rear Park
Assist System
During vehicle start up, when the ParkSense
Rear Park Assist System has detected a faulted
condition, the instrument cluster display will
actuate a single chime, once per ignition cycle,
and it will display the "PARKSENSE UNAVAIL-
ABLE
"PARKSENSE UNAVAILABLE SERVICE RE-
QUIRED" message. Refer to "Instrument Clus-
ter Display" for more information. Under this
condition, ParkSense will not operate.
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" appears in the instrument cluster
display make sure the outer surface and the
underside of the rear fascia/bumper is clean and
clear of snow, ice, mud, dirt or other obstruction
and then cycle the ignition. If the message
continues to appear, see your authorized dealer.
25-12 inches
Less than
(65-30 cm)
12 inches
(30 cm)
2nd Flashing
1st Flashing
2nd Flashing
1st Flashing
2nd Flashing
1st Flashing
Continuous
Yes
Yes
WIPE
REAR
SENSORS"
or
the

Advertisement

Table of Contents
loading

Table of Contents