Configuring The Maximum Available Interface Bandwidth - HP MSR4080 Configuration Manual

Configura tion re strictions and guidelines
You can apply a Q
•
remark, car, queue af
• An inbound QoS policy
You must enable the rat
•
Configuration procedure
To apply a policy to an interface or PV
Step
1. Enter system view.
2. Enter interface or PVC view.
3. Apply a policy to the interface
or PVC.

Configuring the maximum available interface bandwidth

The maximum available interface bandwidth refers to the maximum interfa
bandwidth check when CBQ enqueues packets. It is not the actual bandwidth of the physical interface.
If no maximum availa
CBQ calculation:
• The actual baud rate or rate if the interface is a physi
0 kbps if the interface is a virtual interface, for example
•
Configura tion g uidelines
• HP recommends th
the actual available
On subinterfaces, you m
•
calculation.
Config uration procedure
To configure the maximum interface available bandwidth:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the maximum
available bandwidth of
the interface.
oS policy c onfigured w
, queue ef, and queue wfq.
cannot contain these queuing a
e limit function for the que
C:
Command
system-view
•
Enter interface view:
interface interface-type
interface-number
•
Enter PVC view:
a. interface atm
interface-number
b. pvc vpi/vci
qos apply policy policy-name
{ inbound | outbound }
ble bandwidth is configured for an interface, the following bandwidth is used for
at you c onfigure the
band width of the physical interface or logic l link.
ust configure the bandwidth command to p
Command
system-view
interface interface-type interface-number
bandwidth bandwidth-value
ith QoS actions to phys
ctions: queue ef, queue af, or queue wfq.
uing function to t
cal one.
, HDLC link bundle interface.
maximum available interface bandwidth to be smaller than
57
ical in terfaces, for example
ake effect on subinterfaces.
Remarks
N/A
Settings in interface view
effect on the current interface.
Settings in PVC view take effect
on the current PVC.
By default, no QoS policy is
applied to an interface or PVC.
ce bandwidth used for
a
rovide base bandwidth for CB
Remarks
N/A
N/A
For more information about this
command, see In terface
Command Reference.
take
Q