Qppb Configuration Example In An Mpls L3Vpn - HP MSR4080 Configuration Manual

If-match any
Behavior: be
-none-
Classifier: qppb
Matched : 0 (Packets)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped
Operator: AND
Rule(s) :
If-match ip-precedence 1
If-match qos-local-id 3
Behavior: qppb
Committed Access Rate:
CIR 512 (kbps)
Green action
Yellow action : pass
Red action
Green packets : 0 (Packets) 0 (Bytes)
Yellow packets: 0 (Packets) 0 (Bytes)
Red packets

QPPB configuration example in an MPLS L3VPN

Network requ irements
As sh own in
Conf igure QPPB so that Router C can perform the following tasks:
• Receive routes.
Set the QPPB local QoS IDs.
•
Use the QoS policy to limit the traffic rate to 2 Mbps in
•
Figur e 23 Network diagram
Table 4 Interfaces and I
Dev ice
Rou ter A
Rou ter C
0 (Bytes)
: 0/0 (pps/bps)
, CBS 32000 (Bytes), EBS 512 (Bytes)
: pass
: discard
: 0 (Packets) 0 (Bytes)
Figure 23, all routers run BGP.
P address assignment
Interface IP address
GE2/1/0 192.168.1.2/24
GE2/1/1 167.1.1.1/24
GE2/1/0 169.1.1.2/24
GE2/1/1 168.1.1.1/24
each direction.
Device Interface
GE2/1/0
Router B
GE2/1/1
GE2/1/1
Router D
GE2/1/0
80
IP address
167.1.1.2/24
168.1.1.2/24
169.1.1.1/24
192.168.3.2/24