Defining A Class; Defining A Traffic Behavior - HP MSR4080 Configuration Manual

Associates the predefined class default-class with the predefined traffic behavior be.
•

Defining a class

t S ep
1. Enter system view.
2. Create a class and
enter class view.
3. Configure match
criteria.
Defin ing a traffic behavior
To define a traffic behavior, create the traffic behavi
behavior view.
Configur e AF and the minimum guaranteed bandwidth
When you configure AF and the minimum guaranteed bandwidth, follow these guidelines:
You can apply this traffic behavior only to the outgoing traffic of an interface.
•
You cannot configure the queue ef command together with the queue af command in the sam
•
traffic behavior.
To configure que
•
following units:
Bandwidth.
Percentage of the available bandwidth.
Percentage of the remaining bandwidth.
To configure both the queue ef command and the queue af command in a policy, you must
•
configure them in the same unit (either bandwidth or per
percentage of the remaining bandwidth, you can config
T o conf igure AF and the minimum
S ep t
1. Enter system view.
2. Create a traffic behavio
enter traffic behavior v
3. Configure AF and the
minimum guaranteed
bandwidth.
Configuring EF and the maximum bandwidth
When you configure EF and the maximum bandwidth, follow these guidelines:
Command
system-view
traffic classifie r
classifier-name [ operator
{ and | or } ]
if-match [ not ] match-criteria
ue af for multiple classes of a policy, you must configure them in one of the
guaranteed
Command
system-view
r and
traffic behavior behavior-name
iew.
queue af bandwidth { ba
pct percentage | remaining-pct
remain ing-percentage }
Remarks
N/A
By default, no class is created.
By default, no match criterion is configu
For more info
criteria, see ACL and QoS Command
Reference.
or first and then configure QoS attributes in traffic
centage). When you configure AF in
ure EF in an absolute value or percentage.
bandwidth:
ndwidth |
53
rmation about configuring match
Remarks
N/A
By default, no behavior is created.
By default, AF is not configured.
red.
e