Enabling QPPB on the route receiving interface
Step
1.
Enter system view.
2.
Enter interface view.
3.
Enable QPPB
Configuring a QoS policy
The c
lasses in the QoS policy
criter
ia.
Applying
the QoS policy to an
Ste
p
1.
Enter system view.
2.
Enter interface view.
3.
Apply the specified policy to
the interface.
QPPB c
onfiguration examples
QPPB configuration example in an IPv4 network
Network requ
irements
As sh
own in
Conf
igure QPPB so that Router B can perform the follow
Receive routes.
•
Set IP precedence values and local QoS IDs according to the r
•
•
Use the QoS policy to limit the traffic rate to 512 kbps.
on the interface.
use the IP precedence and local QoS ID set by the routing policy as match
Command
system-view
interface interface-type
interface-number
qos apply policy policy-name
{ inbound | outbound }
Figure
22, all routers run BGP.
Command
system-view
interface interface-type
interface-number
bgp-policy { destination | source }
{ ip-prec-map | ip-qos-map } *
interface
ing tasks:
77
Remarks
N/A
N/A
By default, QPPB is disabled.
The command applies to only
incoming traffic.
Remarks
N/A
N/A
By defa
ult, a QoS policy is not
applied.
outing policy.