Configuring Priority Marking; Configuration Procedure - HP MSR4080 Configuration Manual

Configuring priority marking

Priority marking sets the priority fi
you can use priority marking to set IP precedence or DSCP for a traffic class o
forwarding of these packets
To configure priority marking, you a
priority marking action to s
Priority marking can be used tog h
priority mapping."
Co nfiguration
To configure priority marking:
Step
1. Enter system view.
2. Create a traffic class and
enter traffic class view.
3. Configure match criteria.
4. Return to system view.
5. Create a traffic behavior
and enter traffic behavior
view.
6. Configure a priority
marking action.
7. Return to system view.
elds or flag bits o
.
c n associate a traffic class with a traffic be
et the pri ority f ields or flag bits of the traffic class o
et er with priority mapping. For more
proce dure
Command
system-view
traffic classifier classifier-name [ operator { and
| or } ]
if-match [ not
quit
traffic behavior behavior-name
•
Set the DSCP value for packets:
remark dscp dscp-value
•
Set the 802.1p priority for packets:
remark dot1p dot1p-value
Set the IP precedence for packets:
remark ip-precedence ip-precedence-value
•
Set the local precedence for packets:
remark local-precedence
local-precedence-value
•
Set the local QoS ID for packets:
remark qos-local-id local-id-value
quit
f packets to modify the priori
] match-criteria
68
ty of packets. For examp
f IP packets to co ntrol the
h avior configured with the
f packets.
infor mation, see "Configuring
Remarks
N/A
By default, no traffic class
is configured.
By default, no match
criterion is configured.
For more inform ation
about the if-match
command, see ACL and
QoS Command
Reference.
N/A
By default, no traffic
behavior is configured.
Use one of the
commands.
By default, no priority
marking action is
configured.
N/A
le,