HP MSR4080 Configuration Manual page 84

# Bind interface GigabitEthernet 2/1/0 to the VPN instance vpn1.
[RouterB] interface gigabitethernet 2/1/0
[RouterB-GigabitEtherne
[RouterB-GigabitEthernet
[RouterB-GigabitEthernet2/1/0] quit
# Enable MPLS on interface GigabitEthernet 2/1/1.
[RouterB] interface gigabitether
[RouterB-GigabitEthernet2/1/1] mp
[RouterB-GigabitEthernet2/1/1] mpls ldp enable
[RouterB-GigabitEthernet2/1/1]
4. Configure Router C:
# Configure a VPN instance.
<RouterC> system-view
[RouterC] ip vpn-instance vpn1
[RouterC-vpn-instance-vpn1] route-distingui
[RouterC-vpn-instance-vpn1] vpn-target 200:1 ex
[RouterC-vpn-instance-vpn1] vpn-target 200:1 imp
[RouterC-vpn-instance-vpn1] quit
# Configure a BGP connection.
[RouterC] router id 2.2.2.2
[RouterC] bgp 200
[RouterC-bgp] peer 1.1.1.1 as-number 200
[RouterC-bgp] peer 1.1.1.1 connect-in
[RouterC-bgp] ip vpn-instance vpn1
[RouterC-bgp-vpn1] peer 169.1.1.1 as-number
[RouterC-bgp-vpn1] address-family ipv4
[RouterC-bgp-ipv4-vpn1] peer 169.1.1.1 enable
[RouterC-bgp-ipv4-vpn1] peer 169.1.1.1 route-policy qppb import
[RouterC -bgp-ipv4-vpn1] quit
[RouterC-bgp-vpn1] quit
[RouterC-bgp] address-family vpnv4
[RouterC-bgp-vpnv4] peer 1.1.1.1 enab
[RouterC-bgp-vpnv4] pee
[RouterC-bgp-vpnv4]
[RouterC-bgp] quit
# Configure a routing policy.
[RouterC] route-policy qppb permit
[RouterC-route-policy-qppb-0] apply qos-lo
[RouterC-route-policy-qppb-0] quit
# Configure MPLS.
[RouterC] mpl s lsr-id 2.2.2.2
[RouterC] mpls ldp
[RouterC-mpls-ldp] quit
# Configure OSPF.
[RouterC] ospf
[RouterC-ospf-1] area 0
[RouterC-ospf-1-area-0.0.0.0] network 2.2.2.2 0.0.0.0
t2/1/0] ip binding vpn-instance vpn1
2/1/0] ip address 167.1.1.2 24
net 2/1/1
ls enable
quit
terface loopback 0
le
r 1.1.1.1 route-policy qppb import
quit
node 0
82
sher 200:1
port-extcommunity
ort-extcommunity
300
cal-id 1023