Configuring A Qos Policy; Non-Mqc Approach; Mqc Approach; Configuration Procedure Diagram - HP MSR4080 Configuration Manual

Configuring a QoS policy

In this chapter, "MSR1000" refers to MSR1002-4. "MSR2000" refers to MSR2003, MSR2004-24,
MSR2004-48. "MSR3000" collectively refers to MSR3012, MSR3024, MSR3044, MSR3064.
"MSR4000" collectively refers to MSR4060 and MSR4080.
You can configure QoS by using the MQC approach or non-MQC approach. Some features support
both approaches, but some support only one.

Non-MQC approach

In the non-MQC approach, you configure QoS service parameters without using a QoS policy. For
example, you can use the rate limit feature to set a rate limit on an interface without using a QoS policy.

MQC approach

In the modular QoS configuration (MQC) approach, you configure QoS service parameters by using
QoS policies. A QoS policy defines the shaping, policing, or other QoS actions to take on different
classes of traffic. It is a set of class-behavior associations.
A traffic class is a set of match criteria for identifying traffic, and it uses the AND or OR operator:
If the operator is AND, a packet must match all the criteria to match the traffic class.
•
If the operator is OR, a packet matches the traffic class if it matches any of the criteria in the traffic
•
class.
A traffic behavior defines a set of QoS actions to take on packets, such as priority marking and redirect.
By associating a traffic behavior with a traffic class in a QoS policy, you apply the specific set of QoS
actions to the traffic class.

Configuration procedure diagram

Figure 4 shows how to configure a QoS policy.
20