12.2010
• Remove the front cover of the SINAMICS DCM
①
•
Break-off the extension of the module A7126 Allocation Board
②
•
Using the guide slots in the holder for the electronic modules, position the Firing Unit Trigger
Board A7103 and by shifting the plug connection (X110), establish a connection to the
Allocation Board A7126
③
•
Fasten the Firing Unit Trigger Board A7103 using the screw provided, tightening torque
1 Nm
④
•
The BOP holder can be released at the side and swung upwards to route the connecting
cable
• After connecting the cable (see Chapter 6.3.3) relocate the front cover of the SINAMICS DCM
and fasten using all of the screws
Siemens AG
6RX1700-0DD74
SIMOREG DC-MASTER Converter Commutation Protector
Operating Instructions
Installation
25
ENGLISH