Yamaha 2001 YZ426F/LC Owner's Service Manual page 510

b
1
EC5B5000
ASSEMBLY AND INSTALLATION
Handlebar
NOTE:
NOTE:
NOTE:
90˚
c
2
5 - 42
HANDLEBAR
1. Install:
Handlebar 1
Handlebar holder 2
Bolt (handlebar holder) 3
28 Nm (2.8 m · kg, 20 ft · lb)
The upper handlebar holder should be
installed with the punched mark a forward.
First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts
on the rear side.
2. Install:
Grip (left) 1
Apply the adhesive to the handlebar 2.
Before applying the adhesive, wipe off
grease or oil on the handlebar surface a
with a lacquer thinner.
Install the grip (left) to the handlebar so that
the line b between the two arrow marks
faces straight upward.
3. Install:
Grip (right) 1
Collar 2
Apply the adhesive on the tube guide
3.
Before applying the adhesive, wipe off
grease or oil on the tube guide surface a
with a lacquer thinner.
Install the grip to the tube guide so that the
grip match mark b and tube guide slot c
form the angle as shown.
CHAS