Yamaha 2001 YZ426F/LC Owner's Service Manual page 132

Ô Fasten the TPS lead (in the
sub wire harness) under the
frame so that it does not con-
tact the carburetor.
Fasten the TPS lead under the
coupler to the frame with a
plastic locking tie.
Ò Pass the carburetor breather
hose and overflow
between the connecting rod
and cross tube (frame).
˜ Fasten the neutral switch lead
and oil hose together with a
plastic locking tie and cut off
the tie end.
ˆ Fasten
the cylinder
breather hose and
switch lead to the frame with a
plastic locking tie.
CABLE ROUTING DIAGRAM
Ø Fasten the neutral switch lead
to the frame with a plastic
band.
∏ Fasten
breather hose with the hose
holder.
ΠPass the clutch cable through
the cable guide.
 Fasten the neutral switch lead
hose
and CDI magneto lead together
with a plastic band.
Í Pass the clutch cable on the
inside the
breather hose.
Ê Pass
the
head breather hose along the inner
neutral side of the radiator pipe.
the cylinder head
cylinder head
cylinder head
2 - 22
SPEC
Ë Pass the radiator breather
hose from the right side of the
frame to the left side, over radi-
ator pipe 1, along the inner side
of radiator hose 4 and the radi-
ator, and between the lower
engine bracket, crankcase, oil
hose and the frame.
◊ Pass the clutch cable between
the frame and radiator and
over the lower boss on the radi-
ator.