Ethernet Leds; Step 6-Startup And Software Configuration - Sierra Wireless AirLink LS300 Hardware User's Manual

Rev 5 Apr. 13

Ethernet LEDs

The connector has two LEDs that indicate speed and activity. When looking into
the connector:
• Activity – The right LED is solid yellow when a link is detected (the cable is
plugged in) and blinks when there is activity.
• Connection Speed – The left LED is green to indicate a 100 Mbps link and
orange when either no cable is connected or a 10 Mbps link is detected.
Step 6—Startup and Software
Configuration
You can configure the ALEOS software on the LS300 using:
• ACEmanager (browser-based application)
• AirVantage Management Service
• AT Commands
Configuring with ACEmanager
To access ACEmanager:
1. Connect a laptop to the device with an Ethernet cable.
2. Launch your web browser and go to http://192.168.13.31:9191.
Note: It takes the device 2–3 minutes to respond after power up.
Figure 3-8: ACEmanager login window
3. Enter the default password, 12345 and click Log in.
4. Refer to the ALEOS Software Configuration User Guide for information on
how to use ACEmanager to configure your LS300.
Configuring with AirVantage Management Service
AirVantage Management Service (AVMS) allows the management of all your
devices remotely from one user interface.
Some of its features include:
• Centralized, remote monitoring for all of your AirLink devices.
• Continuous status monitoring of important health data such as signal
strength.
Installation and Startup
(cloud-based application)
27