Sierra Wireless AirLink LS300 Hardware User's Manual page 14

AirLink LS300 Hardware User Guide
Table 2-1: Specifications
Host Interfaces
Input / Output
Power Adapter pins
Reset
LEDs
Dimensions
Screw Torque Settings
Power Consumption
Operating Temperature
Humidity
Reverse Polarity
Protection
14
•
10/100 Base-T RJ45 Ethernet
•
RS-232 serial port
•
USB V2.0 Micro-B connector
•
2 SMA antenna connectors (Primary, GPS/Diversity)
•
Active antenna support
Configurable I/O pin on power connector
•
Digital Input ON voltage: 3.3 to 30 VDC
•
Digital input OFF voltage: 0 to 1.2 VDC
•
Analog input voltage: 0 to 30 VDC
•
Open collector output < 200mA @ 30 VDC: 3.3 to 30 VDC
4-Pin connector:
•
Power
•
Ground
•
Configurable digital I/O and analog voltage input sensing
•
Configurable ignition sense (Low Power Mode Enable Input)
•
Manual reset button or using ACEmanager
4 LEDs:
•
Network
•
Signal
•
Activity
•
Power
•
3.0 in x 3.5 in x 1.0 in
(76 mm x 90 mm x 25 mm)
•
6.7 oz. (190 g)
•
M3 DIN rail mount screws
10 in-lb. (1.1 N-m)
Antennas
Finger tight (5–7in-lb.) is sufficient and the max torque should not go
beyond 10 in-lb. (1.1 N-m).
All values in mA @ 12 VDC
•
HSPA+: Idle 224, typical 245, maximum 430
•
CDMA: Idle 220, typical 257, maximum 427
•
Low power standby mode: < 68
•
Analog ignition sense and power management
•
Input voltage: 7–28 VDC
-30°C to +70°C (-22°F to 158°F) full 3GPP RF compliance
-40°C to +85°C (-40°F to 185°F) reduced RF performance
90% RH @ 60°C
Compliant
4112895