Step 1-Insert The Sim Cards - Sierra Wireless AirLink RV50 Series Hardware User's Manual

Step 1—Insert the SIM Cards
The AirLink RV50 Series gateway has two mini-SIM (2FF) card slots. The upper slot is
Slot 1 and the lower slot is Slot 2. ACEmanager references these slot numbers, and by
default, the SIM card in Slot 1 is the Primary SIM card. If you are using only one SIM card,
Sierra Wireless recommends that you install it in Slot 1.
If the SIM card (or SIM cards) have not already been installed, insert the SIM cards into
the gateway before connecting any external equipment or power to the gateway.
To install the SIM cards:
1. Use a #1 Phillips screwdriver to remove the SIM card cover.
2. Orient the SIM card(s), as shown in
3. Gently slide the SIM cards into the slots until they click into place.
SIM card cover
#1 Phillips screws
4. Replace the SIM card cover.
Rev. 6 October 2021
card face down, and the gold contacts on the lower SIM card face up. If you are using
only one SIM card, insert it in the upper SIM slot (Slot 1).
To remove a SIM card, press the SIM card in, and release it. Gently grip the SIM card
and pull it out.
SIM Card
1
2
Upper SIM card
(SIM Slot 1)
Figure 3-1: Installing the SIM Card
Figure 3-1. The gold contacts on the upper SIM
21
Installation and Startup
Reset
Note the orientation of notched corners
for proper SIM card alignment.
Lower SIM card
(SIM Slot 2)
4117313