Editing Point Label; Clear Point Label; Saving Changes - Simplex 4006-9121 Technical Manual

Note: Elevator recall requires the following:
• The relay must have a function type of Primary or Alter-
nate and must be wired to the appropriate elevator con-
trol contact.
• The IDC zones used to trigger elevator recall must be
associated with the following alarm groups.
- Alarm Group 98. Associate all zones used to recall
the elevator to the primary floor in this alarm
group.
- Alarm Group 97. Associate all zones used to recall
the elevator to the alternate floor in this alarm
group.

Editing Point Label

This option allows you to assign a 20-character custom label
to each relay point.
1. Follow the steps in "Accessing Menus". Make sure to
choose Relay as the type of device to program.
<ENTER>=Accept
Prg: [RELAY]
2. Press <ENTER>, and then use <NEXT> and <PREV>
keys to choose the relay (AUX1, AUX2, etc.) to pro-
gram.
AUX1
Alarm
3. Press <ENTER>, and then use the <NEXT> and
<PREV> keys until <Edit Label> is displayed. For
example:
AUX1
Fn: [Edit Label]
4. Press <ENTER>. A cursor appears beneath the leftmost
letter of the currently assigned custom label. Use the left
and right arrow keys to move the cursor between letters.
You can edit a label in one of three ways:
• Using the Keypad. Press the alphanumeric key cor-
responding to the letter you want. For example, for
the letter "C", press the "2" key on the keypad three
times. Use the left and right arrow keys to move to
the next letter in the label.
• Use the <NEXT> and <PREV> keys. Each time
you press the <NEXT> key, the display advances to
the next character. Likewise, each press of the
<PREV> key moves backward one character.
Technical Manuals Online! - http://www.tech-man.com
Chapter 3. Programming IDCs, NACs, and AUX Relays
1/2
3-9
Use the left and right arrow keys to move to the
next letter in the label.
• Use the Word Library, which is a stored list of com-
mon words sorted alphabetically. Press the
<FUNCTION> key on the front panel. A prompt
similar to the following appears.
AUX1
<FUNC>=Word Library
To jump to a word, press the alphanumeric key cor-
responding to the first letter in the word. For exam-
ple, to use the word Floor, press the "3" key
repeatedly until Floor appears.
Refer back to Table 3-2 for a list of words in the
library.
5. Pressing <ENTER> saves the current label. Pressing
<EXIT/CLEAR> will quit label editing without saving.
Pressing the <ENTER> key will save the current label,
and <EXIT/CLEAR> will quit label editing without
saving.

Clear Point Label

The "Clear Point Label" menu performs the same function as
"Edit Point Label" described above except that it clears the
point's currently assigned label first.

Saving Changes

When IDC, NAC, and relay programming is complete, press
the EXIT/CLEAR key until the following prompt is shown.
[Cont] Dscrd
Use the right arrow key to move the cursor to one of the fol-
lowing options and press <ENTER>.
• Cont - continues the edit session.
• Dscrd - exits the edit session without saving your
changes (keeps the job that was loaded before you
started editing).
• Save - saves your edit changes
Note: Both discard and save restart the panel.
Save