Table of Contents
Advertisement
Control Modes
There are 4 modes:
One Galactic
(Auto run visual
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the Galactic is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 14 for more information about the Auto run visual effects.
One Galactic (Sound-control)
1.
Fasten the effect light onto firm trussing
2.
Turn on the music. If the device is set to sound, then the Galactic will react to the beat of the music.
Please see page 14 for more information about the sound-control options.
Multiple Galactics
1.
Fasten the effect light onto firm trussing
2. Always use a safety cable (ordercode 70140 / 70141).
3.
Use a 3-p XLR cable to connect the Galactic lasers.
The pins:
4.
Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 14 (Autorun or
control). This means on the master device you can set your desired operation Mode and all slave
devices will react the same as the master device.
• Auto run (visual effects)
• Sound-controlled
• Master/Slave
• DMX512
effects)
(Master/Slave control)
1.
Earth
2.
Signal -
3.
Signal +
Multiple Galactics
Leave at least 1 meter on all sides for air circulation.
Leave at least 1 meter on all sides for air circulation.
(Master/Slave control)
10
Music
Fig. 3
Advertisement
Table of Contents
