Oki ES5112dn Maintenance Manual page 62

4. While the message "PRINT EXECUTE" that is set by the operation specified in
step 2 is being displayed, press the [OK] key and the test print is executed with
the setting value that has been set by steps 2 and 3.
Pressing the [CANCEL] key stops the test print.
If any alarm that is shown in the following details column is issued at startup of
test print or while test print is in progress, the test print is interrupted. (For error
details, refer to section 2.5.1 LCD Status Message/ Trouble Table. However, the
comment to be displayed is different in the case of the PU test print.)
Panel display
PAPER END
SELECTED TRAY
SELECTED TRAY IS
NOT INSTALLED
REMOVE PAPER
OUT OF DUPLEX
INSTALL CASSETTE TRAY
OPEN
Print pattern (It cannot be used for checking PQ.)
0:Write paper print
1:2x2 print
2:4x4 print
3:Horizontal line print
4:Slash line print
5:Vertical line print
6:White paper print
7:Black paper print
8 to 15:White paper print
• During printing, the following messages are displayed.
P=***
P : Number of test print copies (unit: copies)
Details
No paper
Selected tray is not installed.
DUPLEX internal error
Cassette removal
• Displays are switched by pressing the [MENU
T=*** U=***[###]
H=***%
U : *** = Upper heater temperature measurement value [unit:
[***] = Print execution target temperature [unit:
T : Environment temperature measurement value [unit:
H : Environment humidity measurement value [unit: % ]
• Displays are switched by pressing the [MENU
KTR=*.**
KTR indicate the transfer voltage setting value. (unit: KV)
• Displays are switched by pressing the [MENU
KR=*.**
KR : BLACK transfer roller resistance value [unit: uA]
• Displays are switched by pressing the [MENU
ETMP=***UTMP=***
ETMP : Hopping motor constant speed correction parameter
(environment temperature) [unit: DEC]
UTMP : Fuser motor constant speed correction parameter
(fuse target temperature) [unit: DEC]
3. ADJUSTMENT
]
key.
]
]
]
] key.
] key.
]
key.
3-18