Powerware Prestige 6000 Installation And Operator's Manual page 62

UPS Operation
54 Powerware
4. Plug the input and output cords of the PPDM into the power
connectors on the PPU as shown in Figure 19 on page 52.
5. Switch the PPU input breaker to the ON (
After a short delay (approximately three seconds), the UPS

front panel indicators turn on and cycle through several times.
The and
in Bypass mode).
6. Press and hold the Output On button until you hear the UPS
beep (approximately one second).

The indicator remains lit and the Self Test indicator
turns on.
7. Turn the Bypass switch on the PPDM to the NORMAL position.
The front panel displays the percentage of full load being
applied to the UPS. The UPS is now in Normal mode with the
load online.
® Prestige Series Installation and Operator's Manual for IBM Applications (6000 VA) Uncontrolled Copy
Figure 20. Voltage Selector Switch
indicators remain lit for several seconds (UPS
Voltage
Selector
Switch
) position.
|