Download Print this page

Start/Stop Button - Hartmann TENSOVAL MOBILE Instructions For Use Manual

Hide thumbs Also See for TENSOVAL MOBILE:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 152
ured values are in memory, the
mean value will be calculated from
these two measured values. If only
one measured value is in memory,
no mean value will be calculated.
You can cancel the memory's recall
of data at any time by pressing the
START/STOP button. Otherwise the
device will switch itself off auto-
matically after approx. 30 seconds.
Even if the power supply fails, e.g.
when changing the batteries, the
stored values will still be available.
5.3 Deleting the measured
values
You can delete all stored data
either in M1 or in M2. To do this,
press the memory button of the
corresponding memories M1 or M2.
The average value will appear on
the display. Hold down the memory
button for a longer time. After four
seconds, the display will fl ash and
after further four seconds, all data
will be deleted. On the display
appears now M1 or M2.
Important: If you release the
memory button before the
end of the time limit, no data will
be deleted. If there is only a single
6 TM IV_GA_GB.indd 168
6 TM IV_GA_GB.indd 168
measured value in memory, this
stored value cannot be deleted. It
is not possible to delete individual
values.
5.4 Using the guest mode
When a third person uses Tensoval
mobil, it is recommended that they
use the guest mode. This one is used
to store a measured value neither
to the memory positions M1 nor to
M2. This avoids bias to the average
values and stored values of the
two main users of the device. To
take measurements in guest mode,
start the measuring procedure by
simultaneously pressing memory
buttons M1 and M2. The START/STOP
button need not be pressed.
At the end of measurement the
display simultaneously shows both
M1 and M2 above the measured
values rather than either symbol
alone. The measured value can thus
not be applied to either person,
and the measured values will not
be stored.
To switch off the device, press the
START/STOP button, also in guest
mode. Otherwise the device will
switch itself off automatically after
3 minutes.
168
6.
Er
oc
De
on
Cu
27.06.13 12:57
27.06.13 12:57

Hide quick links:

Advertisement

loading