Hartmann TENSOVAL MOBILE Instructions For Use Manual page 165

ou
e,
ill
5.2 Recalling the measured
values
n The device must be switched off to
recall data from memory. Press M1
s for the fi rst person's stored values
and M2 for the second person's
values. The corresponding symbols
. M1 or M2 will be displayed. First,
es the mean value of all stored values
nts for a person will be displayed. An
"A" (for the English designation
"Average") appears on the display
and the number displayed in the
or top right-hand corner indicates the
o number of measurements, from
which the average value was
calculated (see fi g.).
e
6 TM IV_GA_GB.indd 167 6 TM IV_GA_GB.indd 167
When pressing again, the most
recently stored measured value will
be displayed. By repeatedly press-
ing the memory button all stored
values of the selected memory
can be recalled one by one. The
measured value and the number of
the memory position are displayed
when you access stored values.
The number of the memory posi-
tion, the date and time appear in
2 – 3 second intervals. Tensoval
mobil can store up to 60 measured
values for each person (M1 or M2).
The most recent measured value is
always in memory position No.1.
When all memory positions are
occupied the oldest value will be
deleted each time.
Important: The calculated
mean value is based on all
measured values stored for the
respective person. If only two meas-
167
English
GB
27.06.13 12:57 27.06.13 12:57