Connecting Additional Amplifiers; Connecting Am/Fm Antennas - Pioneer VSX-930-k Operating Instructions Manual

03

Connecting additional amplifiers

This receiver has more than enough power for any home use, but it's possible to add additional amplifiers to front
and subwoofer channels of your system using the pre-outs. Make the connections shown below to add amplifiers
to power your speakers.
For Taiwan
AUDIO OUT
L
FRONT 1
PRE OUT
SUBWOOFER
R PRE OUT
2
AUDIO OUT
L
FRONT 1
PRE OUT
SUBWOOFER
R PRE OUT
2
MONITOR OUT
For other regions
AUDIO OUT
1
SUBWOOFER
PRE OUT
2
AUDIO OUT
1
SUBWOOFER
PRE OUT
2
MONITOR OUT
! If you're not using a subwoofer, change the front speaker setting (see
LARGE.
! If you have two subwoofers, the second subwoofer can be connected to the SUBWOOFER 2 terminal.
Connecting two subwoofers increases the bass sound to achieve more powerful sound reproduction. In this
case, the same sound is output from the two subwoofers.
! To hear sound only from the pre-outs, switch the speaker terminals to SP: OFF
nect any speakers that are connected directly to the receiver.

Connecting AM/FM antennas

Connect the AM loop antenna and the FM wire antenna as shown below. To improve reception and sound quality,
connect external antennas (see
ANALOG
INPUT
L
Front channel
R
amplifier
ANALOG
INPUT Powered
subwoofer 1
ANALOG
INPUT
Powered
subwoofer 2
1
ANALOG
INPUT
Powered 2
subwoofer 1
secure the AM antenna wires.
3
ANALOG
INPUT
Powered
To fix the stand to the antenna, bend in the direction indicated by the arrow (fig. a) then clip the loop onto the
subwoofer 2
stand (fig. b).
! If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. c) before
4
5
Speaker Setting on page 103 ) to
For best results, extend the FM antenna fully and fix to a wall or door frame. Don't drape loosely or leave coiled up.
(page 87 ) or simply discon-
31
Connecting your equipment (In case of VSX-930)
Connecting external antennas
a
ANTENNA
5
AM LOOP
FM UNBAL
75
1
Pull off the protective shields of both AM antenna wires.
Push open the tabs, then insert one wire fully into each terminal, then release the tabs to
Fix the AM loop antenna to the attached stand.
clipping the loop to the stand. Make sure the reception is clear.
Place the AM antenna on a flat surface and in a direction giving the best reception.
Connect the FM wire antenna into the FM antenna socket.
on page 32 ).
b c
3
4
2