Table of Contents
Advertisement
04
1
Pull off the protective shields of both AM antenna wires.
2
Push open the tabs, then insert one wire fully into each terminal, then release the tabs to
secure the AM antenna wires.
3
Fix the AM loop antenna to the attached stand.
To fix the stand to the antenna, bend in the direction indicated by the arrow (fig. a) then clip the loop onto the
stand (fig. b).
! If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. c) before
clipping the loop to the stand. Make sure the reception is clear.
4
Place the AM antenna on a flat surface and in a direction giving the best reception.
5
Connect the FM wire antenna into the FM antenna socket.
For best results, extend the FM antenna fully and fix to a wall or door frame. Don't drape loosely or leave coiled up.
Connecting external antennas
To improve FM reception, connect an external FM antenna to FM UNBAL 75 W.
ANTENNA
AM LOOP
FM UNBAL
75
To improve AM reception, connect a 5 m to 6 m length of vinyl-coated wire to the AM LOOP terminals without
disconnecting the supplied AM loop antenna.
For the best possible reception, suspend horizontally outdoors.
Outdoor antenna
Indoor antenna
5 m to 6 m
(vinyl-coated wire)
75
coaxial cable
ANTENNA
AM LOOP
FM UNBAL
75
46
Connecting your equipment (In case of VSX-830)
Connecting to the network through LAN interface
By connecting this receiver to the network via the LAN terminal, you can listen to Internet radio stations. To listen
to Internet radio stations, you must sign a contract with an ISP (Internet Service Provider) beforehand.
When connected in this way, you can play audio files stored on the components on the local network, including
your computer.
NETWORK
to LAN port
NAS
Computer
Connect the LAN terminal on this receiver to the LAN terminal on your router (with or without the built-in DHCP
server function) with a straight LAN cable (CAT 5 or higher).
Turn on the DHCP server function of your router. In case your router does not have the built-in DHCP server func-
tion, it is necessary to set up the network manually. For details, see
LAN terminal specifications
! LAN terminal : Ethernet jack (10BASE-T/100BASE-TX)
Notes
! When connecting the wireless LAN, please use with the wireless LAN antenna upright.
! The range of movement of the wireless LAN antenna is as indicated in the diagram below. There is danger that
you may break it if unnecessary force is applied.
Wireless LAN antenna
! Refer to the operation manual of the equipment you have as the connected equipment and connection method
may differ depending on your Internet environment.
! When using a broadband Internet connection, a contract with an Internet service provider is required. For
more details, contact your nearest Internet service provider.
NETWORK
Internet
Modem
LAN
Router
3
2
1
WAN
LAN cable (sold separately)
to LAN port
Setting network connection
on
page 51
1
.
Advertisement
Table of Contents
