Connecting The Speakers; Installing Your Speaker System - Pioneer VSX-930-k Operating Instructions Manual

03

Connecting the speakers

Each speaker connection on the receiver comprises a positive (+) and negative (–) terminal. Make sure to match
these up with the terminals on the speakers themselves.
This unit supports speakers with a nominal impedance of 6 W to 16 W.
CAUTION
! These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when con-
necting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated
parts.
! Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker terminal. If any
of the bare speaker wire touches the back panel it may cause the power to cut off as a safety measure.
Bare wire connections
CAUTION
Make sure that all speakers are securely installed. This not only improves sound quality, but also reduces the risk
of damage or injury resulting from speakers being knocked over or falling in the event of external shocks such as
earthquakes.
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
1 2
10 mm
Notes
! Please refer to the manual that came with your speakers for details on how to connect the other end of the
speaker cables to your speakers.
! Use an RCA cable to connect the subwoofer. It is not possible to connect using speaker cables.
! If you have two subwoofers, the second subwoofer can be connected to the SUBWOOFER 2 terminal.
Connecting two subwoofers increases the bass sound to achieve more powerful sound reproduction. In this
case, the same sound is output from the two subwoofers.

Installing your speaker system

At the very least, front left and right speakers only are necessary. Note that your main surround speakers should
always be connected as a pair, but you can connect just one surround back speaker if you like (it must be con-
nected to the left surround back terminal).
Standard surround connection
! When only connecting one surround back speaker, connect it to the SURROUND BACK L (Single) terminals.
Front right
3
23
Connecting your equipment (In case of VSX-930)
The top middle terminals can also be used for the front wide and Speaker B speakers.
7.2 ch/5.2.2 ch setting
Top middle right
7.2 ch SB/FW setting
Front wide right
Speaker B setting
Speaker B - right
Subwoofer 1
LINE LEVEL
INPUT
AUDIO OUT
1
SUBWOOFER
PRE OUT
2
5.2ch
FRONT
CENTER
R L
AUDIO OUT
1
SUBWOOFER
PRE OUT
2 5.2ch 7.2ch
SPEAKER B
FRONT CENTER SURROUND SURROUND BACK TOP MIDDLE A
R L R L R L (Single) R L
5.2.2ch
A B
5.2.2ch HDZONE / BI-AMP 5.2.2ch
Surround back speaker terminals can be
used to connect to the sub zone.
7.2 ch/5.2.2 ch setting
Surround back right
7.2 ch SB/FW setting
Surround back right
Speaker B setting
Surround right
Surround back right
HDZONE setting
HDZONE - Right
Top middle left
Front wide left
Speaker B - left
Center Subwoofer 2
LINE LEVEL
INPUT
7.2ch
SPEAKER B
TOP MIDDLE
SURROUND SURROUND BACK
R L R L R L
(Single)
B
HDZONE / BI-AMP
5.2.2ch
Surround back left
Surround back left
Surround left
Surround back left
HDZONE - Left
Front left