At+ Wsqy; At+ Htpmode; At+ Htpsv; At+ Htptp - Jinan USR IOT Technology USR-WIFI232-A2 User Manual

This Instruction only effective for USR-WIFI232-A/B/C works as STA. After USR-WIFI232-A/B/C
module boots up again, the setting will be effective. But user can set this command when module
configured as AP.
4.13.2.2.56

AT+ WSQY

Function: Set/query the critiacl value of network switching.

Format:

Query Operation

AT+ WSQY<CR>
+ok=<ret><CR>< LF ><CR>< LF >
Set Operation

AT+ WSQY=< ret><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:

 ret: The percentage of signal intensity, such as signalstrength was 50%, setting
should be AT+WSQY=50<CR>;
Note: if set to 100, the module will not automatically switch WIFI network.If the users only one
STA parameter, please be sure to set this parameter to 100.
4.13.2.2.57

AT+ HTPMODE

Function: The switch of new/old HTTP headers setting mode(HTTPD Client).

Format:

Query Operation

AT+ HTPMODE<CR>
+ok=<type><CR>< LF ><CR>< LF >
Set Operation

AT+ HTPMODE=< type><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:

type:



4.13.2.2.58

AT+ HTPSV

Function:Set /Query HTTP server IP address and Port Number.

Format:

Query Operation:

AT+HTPSV<CR>
+ok=<IP,Port><CR>< LF ><CR>< LF >
Set Operation:

AT+HTPSV=<IP,Port><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:

IP:HTTP server IP address.

Port:HTTP server Port number。

4.13.2.2.59

AT+ HTPTP

Function:Set /Query HTTP request type.

Jinan USR IOT Technology Limited
USR-WIFI232-A2 User Manual
new: The new HTTP headers setting mode.
old: The old HTTP headers setting mode.
Page 67 of 76
http://www.usriot.com
tec@usr.cn