At+E; At+Entm; At+Netp - Jinan USR IOT Technology USR-WIFI232-A2 User Manual

REGEN
REGTCP
REGID
Notes: USR-WIFI232-A2 module can works as AP or STA, user have to use different AT+ Instruction
to set WiFi parameters when module works as AP or STA mode.
4.13.2.2.1

AT+E

Function: Open/Close show back function;

Format:

AT+E<CR>
+ok<CR>< LF ><CR>< LF >
When USR-WIFI232-A/B/C module firstly switch from transparent transmission to configuration mode,
show back status is open, input "AT+E" to close show back function, input"AT+E" again to open show
back function.
4.13.2.2.2

AT+ENTM

Function: Set module into transparent transmission mode;

Format:

AT+ENTM<CR>
+ok<CR>< LF ><CR>< LF >
When operate this command, module switch from configuration mode to transparent transmission
mode.
4.13.2.2.3

AT+NETP

Function: Set/Query network protocol parameters;

Format:

Query Operation

AT+NETP<CR>
+ok=<protocol,CS,port,IP><CR>< LF ><CR>< LF >
Set Operation

AT+NETP=<protocol,CS,port,IP><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:

protocol:



CS: Network mode:



Port: protocol port ID: Decimal digit and less than 65535

Note: When it is Tcp and Udp Server, the Port can not be 80 (HTTP port), 8000 (websocket port),
49000 (usr - link port).
Jinan USR IOT Technology Limited
USR-WIFI232-A2 User Manual
Client)
Settings/query Registered Package Type
Settings/query Upload Manner
Settings/query Device ID
TCP
UDP
SERVER
CLIENT
Page 49 of 76
http://www.usriot.com
tec@usr.cn