At+Wskeyc - Jinan USR IOT Technology USR-WIFI232-A2 User Manual

Query Operation

AT+WSKEYB<CR>
+ok=<auth,encry,key><CR>< LF ><CR>< LF >
Set Operation

AT+ WSKEYB=< auth,encry,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:

auth: Authentication mode





encry:Encryption algorithm





key: password, ASCII code, shall less than 64 bit and greater than 8bit

This Instruction only effective for USR-WIFI232-A/B/C works as STA. After USR-WIFI232-A/B/C
module boots up again, the setting will be effective. But user can set this command when module
configured as AP.
4.13.2.2.55

AT+WSKEYC

Function: Set/query the third AP's password of 3 sta parameters settings .

Format:

Query Operation

AT+WSKEYC<CR>
+ok=<auth,encry,key><CR>< LF ><CR>< LF >
Set Operation

AT+ WSKEYC=< auth,encry,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:

auth: Authentication mode





encry:Encryption algorithm





key: password, ASCII code, shall less than 64 bit and greater than 8bit

Jinan USR IOT Technology Limited
USR-WIFI232-A2 User Manual
OPEN
SHARED
WPAPSK
WPA2PSK
NONE: When "auth=OPEN", effective
WEP: When "auth=OPEN" or "SHARED", effective
TKIP: When "auth= WPAPSK", effective or "WPA2PSK", effective
AES: When "auth= WPAPSK", effective or "WPA2PSK", effective
OPEN
SHARED
WPAPSK
WPA2PSK
NONE: When "auth=OPEN", effective
WEP: When "auth=OPEN" or "SHARED", effective
TKIP: When "auth= WPAPSK", effective or "WPA2PSK", effective
AES: When "auth= WPAPSK", effective or "WPA2PSK", effective
Page 66 of 76
http://www.usriot.com
tec@usr.cn