Usr-Wifi232-A2 Ethernet Interface Networking (As Sta, N-Ver); Usr-Wifi232-A2 Ethernet Interface Networking (As Sta, Z-Ver) - Jinan USR IOT Technology USR-WIFI232-A2 User Manual

Table of Contents

USR-WIFI232-A2 User Manual

http://www.usriot.com

USR-WIFI232-A/B/C Ethernet Interface Networking (As AP)

Figure 19

USR-WIFI232-A2 module works as AP and also the center of this network. All devices' IP address

in this network shall use the same network segment with USR-WIFI232-A2 and they can

ntercommunication with this method.

4.4.2 USR-WIFI232-A2 Ethernet Interface Networking (As STA, N-Ver)

USR-WIFI232-A2 Ethernet Interface Networking (As STA, N-Ver)

Figure 20

USR-WIFI232-A2 module works as STA (Software is N-Version), and module set as router mode.

When module connect to AP, it will get wireless port IP address from AP (For example:

192.168.1.100). At the same time, module also form a subnet (Default 10.10.100.254) and all

devices connected to module Ethernet interface will get assigned IP address (For example:

10.10.100.101).So as shown, PC1 at internal subnet can initiate a connection to PC2 (For USR-

WIFI232-A2 works as router mode), but PC2 can't active initiate a connection to PC1.

USR-WIFI232-A2 Ethernet Interface Networking (As STA, Z-Ver)

Figure 21

For above networking, USR-WIFI232-A2 module works as STA （ Firmware is Z-Version ） ,and

module configured as bridge mode. When module connect to AP, all devices connected to

module Ethernet interface will get assigned IP address from AP (For example: 192.168.1.101).For

module works as bridge mode, it can be treated as a transparent device and PC1, PC2 can

communicate without any limit. But in this networking, USR-WIFI232-A/B/C module needs assign

Jinan USR IOT Technology Limited

Page 27 of 76

tec@usr.cn

Table of Contents