Quick Configure; Mode Selection Page - Jinan USR IOT Technology USR-WIFI232-A2 User Manual

4.12.2 Quick Configure

This page provides users with a method of rapid configuration module.Users according to the
steps to configure the parameters and restart the module page, you can let the module is normal
work, reduced the configuration steps and time.Of course the options on this page is less, if some
detailed configuration, still need to the corresponding configuration page.
This page has four configuration options and a restart, the corresponding instructions below:
 WI-FI Setting: set the working mode of wifi, AP mode or the STA.
 Ethernet Ports Setting: open/close the Ethernet ports, and set up the corresponding work
mode.
 UART Setting: set serial port parameters, including baud rate, parity bit, 485 functions and so
on.
 Network Setting: set network parameters, Only TCPA related parameters.
 Device Management: when after completion of the above parameters are configured, click
reset module.

4.12.3 Mode Selection Page

This page use to setting the wireless networking mode (AP and STA mode).
"Data transmission mode" selection module working mode are "Transparent Mode", "Serial Command
mode", "HTTPD Client mode", "GPIO mode".
"TCP connection password authentication" can choose whether open TCP password authentication.
Jinan USR IOT Technology Limited
USR-WIFI232-A2 User Manual
Quick Configure Page
Figure 27
Page 37 of 76
http://www.usriot.com
tec@usr.cn