At+Mmid; At+Idfir; At+Ideve - Jinan USR IOT Technology USR-WIFI232-A2 User Manual

Notes: AT+FUDLX is F-Setting, means restore to factory setting will not affect this command.
4.13.2.2.36

AT+MMID

Function: Set/Query Device ID;

Format:

Query Operation

AT+MMID<CR>
+ok=<time><CR>< LF ><CR>< LF >
Set Operation

AT+ MMID=<time><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:

ID: device id(0~65535)

After USR-WIFI232-A/B/C module boots up again, the setting will be effective.
4.13.2.2.37

AT+IDFIR

Function: Enable/Disable "Send an ID when module connection is established" function;

Format:

Query Operation

AT+IDFIR<CR>
+ok=<on/off><CR><LF><CR><LF>
Set Operation

AT+IDFIR=<on/off><CR>
+ok<CR><LF><CR><LF>
Parameters:

On/off: Enable or Disable "Send an ID when module connection is established"

function


4.13.2.2.38

AT+IDEVE

Function: Enable/Disable Every time to send data to send ID function;

Format:

Query Operation

AT+IDEVE<CR>
+ok=<on/off><CR><LF><CR><LF>
Set Operation

AT+IDEVE=<on/off><CR>
+ok<CR><LF><CR><LF>
Parameters:

On/off: Enable or Disable Every time to send data to send ID function



Note: The ID function requires that the server carries out corresponding processing.In front of the
data when module connected to the server with two bytes of ID (ID the range is 0 ~ 65535, the
high byte before,
Jinan USR IOT Technology Limited
USR-WIFI232-A2 User Manual
On, enable "Send an ID when module connection is established" function;
Off, disable "Send an ID when module connection is established" function;
On, enable Every time to send data to send ID function;
Off, disable Every time to send data to send ID function;
and the low byte
Page 61 of 76
behind) plus two bytes
http://www.usriot.com
ID radix-minus-one
tec@usr.cn