At Command Introduction; Configuration Mode - Jinan USR IOT Technology USR-WIFI232-A2 User Manual

USR-WIFI232-A2 User Manual http://www.usriot.com
Device Management Page
Figure 36
Notes: Restart module button: When you setting the parameters of different web pages,
you will click "Apply" button to confirm the setting, but the setting take effect only after
user click the "Restart" button here, the module will re-boot up and refresh the memory
information with new changes.
4.13

AT command Introduction

4.13.1 Configuration Mode

When USR-WIFI232-A2 power up, it will default works as transparent transmission mode, then
user can switch to configuration mode by serial port command. USR-WIFI232-A2 UART default
parameters setting as below figure
USR-WIFI232-A2 Default UART Port Parameters
Figure 37
In configuration mode, user can setting the module through AT+ instruction set, which cover all
web page setting function.
Jinan USR IOT Technology Limited Page 43 of 76 tec@usr.cn