At+Wakey; At+Hidessid - Jinan USR IOT Technology USR-WIFI232-A2 User Manual


This Instruction only effective for USR-WIFI232-A/B/C works as AP. After USR-WIFI232-A/B/C module
boots up again, the setting will be effective. But user can set this command when module configured
as STA.
4.13.2.2.15

AT+WAKEY

Function: Set/Query WIFI security parameters as AP;

Format:

Query Operation

AT+WAKEY<CR>
+ok=<auth,encry,key><CR>< LF ><CR>< LF >
Set Operation

AT+ WAKEY=< auth,encry,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:

auth: Authentication mode





encry:Encryption algorithm






key: password, ASCII code, shall less than 64 bit and greater than 8bit;

This Instruction only effective for USR-WIFI232-A/B/C works as AP. After USR-WIFI232-A/B/C module
boots up again, the setting will be effective. But user can set this command when module configured
as STA.
4.13.2.2.16

AT+HIDESSID

Function: Set/Query hide AP's SSID;

Format:

Query Operation

AT+HIDSSID<CR>
+ok=<sta.><CR><LF><CR><LF>
Set Operation

AT+HIDSSID=<sta><CR>
+ok<CR><LF><CR><LF>
Parameters:

When Query,sta reply if module's SSID is hide;



Jinan USR IOT Technology Limited
USR-WIFI232-A2 User Manual
CH1~CH11
OPEN
SHARED
WPAPSK
WPA2PSK
NONE: When "auth=OPEN", effective;
WEP: When "auth=OPEN", effective or "SHARED", effective;
TKIP: When "auth=WPAPSK", effective or "WPA2PSK", effective;
AES:When "auth=WPAPSK", effective or "WPA2PSK", effective;
TKIPAES:When "auth=WPAPSK", effective or "WPA2PSK", effective;
On-not hide SSID
Off- hide SSID
Page 54 of 76
http://www.usriot.com
tec@usr.cn