Table of Contents
Advertisement
5700 STEP TOP ACC
D.
Traditional Leg Installation
Included with Appliance: Leg brackets; inside firebox.
Tools Required: 9/16 socket wrench and phillips screw driver.
Installing your traditional legs to your appliance.
1. Remove leg brackets from inside of firebox of appliance.
2. Lay body of stove on its back on a protective pad or pallet.
3. Remove four screws from bottom of appliance (Figure 20.1).
4.
Install leg brackets to bottom of appliance using the four just
removed screws in step 3.
NOTE: There is a right and a left of the leg brackets
5. Install six screws to the bottom of the leg brackets
20.1).
6. Attach legs onto leg brackets and secure with bolts and wash-
ers.
7.
Carefully stand stove up and place in desired
CAUTION
Do NOT tilt the appliance on the cast iron legs.
•
Tilting could lead to property damage.
•
Lift the appliance upright and place it into position on the
floor protector.
8.
Thread allen bolts through nuts until flush (Figure 20.2)
9.
Slide allen bolt/nut assemblies into slots of two of the legs with
the nuts on the bottom (Figure 20.3).
Note:
Legs with leveling bolts need to be on opposite sides of the
appliance - one in the front and one in the back (Figure 20.1)
10.
Use allen wrench to adjust legs up and down to desired level
(Figure 20.4).
3
2
Figure 20.1
20
CHECK BAFFLE BOARDS & CERAMIC BLANKET!
•
•
(Figure
20.1).
(Figure
location.
Figure 20.3
5
6
4
7038-206F
Caution!
Verify that the baffle boards and ceramic blanket are
in their proper locations.
It is important that the baffle boards and ceramic blan-
ket are in correctly installed for proper burn safety.
Figure 20.2
9
Figure 20.4
September 27, 2016
Advertisement
Table of Contents
