Traditional Leg Installation - Quadra-Fire 4300 Series Installation Manual

4300 Wood Appliance Series ACC
D. Traditional Leg Installation
Included with Appliance: Leg brackets; inside firebox.
Tools Required: 9/16 socket wrench and Phillips screw
driver.
Installing your traditional legs to your appliance:
1. Remove leg brackets from inside of firebox of
appliance.
2. Lay body of appliance on its back on a protective pad
or pallet.
3. Remove four screws from bottom of appliance (Figure
24.1).
4. Install leg brackets to bottom of appliance using the
four just removed screws in step 3.
NOTE: There is a right and a left of the leg brackets
24.1)
.
5. Install six screws to the bottom of the leg brackets
(Figure 24.1).
6. Attach legs onto leg brackets and secure with bolts and
CAUTION
Do NOT tilt the appliance on the cast iron legs.
• Tilting could lead to property damage.
• Lift the appliance upright and place it into position on the
floor protector.
washers.
7. Carefully stand appliance up and place in desired
location.
8. Thread Allen bolts through nuts until flush (Figure 24.2)
9. Slide Allen bolt/nut assemblies into slots of two of the
legs with the nuts on the bottom (Figure 24.3).
Legs with leveling bolts need to be on opposite
NOTE:
sides of the appliance - one in the front and one in
the back (Figure 24.1)
10. Use Allen wrench to adjust legs up and down to desired
level (Figure 24.4).
3
2
Figure 24.1
24
(Figure
5
6
4
CHECK BAFFLE BOARDS & CERAMIC BLANKET!
• Verify that the baffle boards and ceramic blanket are
in their proper locations.
• It is important that the baffle boards and ceramic
blanket are correctly installed for proper burn safety.
Figure 24.2
Figure 24.3
9
Figure 24.4
7037-172G
CAUTION!
August 13, 2018