Traditional Leg Installation - Quadra-Fire 43ST-ACC-AU Installation Manual

Hide thumbs Also See for 43ST-ACC-AU:
Table of Contents

Advertisement

E. Traditional Leg Installation
Installing your traditional legs to your appliance:
1. Remove leg brackets from inside of firebox of appliance.
2. Lay body of appliance on its back on a protective pad or
pallet.
3. Remove four screws from bottom of appliance
(Figure 22.1).
4. Install leg brackets to bottom of appliance using the four
just removed screws in step 3.
NOTE: There is a right and a left of the leg brackets
(Figure 22.1)
.
5. Install six screws to the bottom of the leg brackets
(Figure 22.1).
6. Attach legs onto leg brackets and secure with bolts
and washers.
Do NOT tilt the appliance on the cast iron legs.
• Tilting could lead to property damage.
• Lift the appliance upright and place it into position on
the floor protector.
7. Carefully stand appliance up and place in desired location.
8. Thread Allen bolts through nuts until flush (Figure 22.2)
9. Slide Allen bolt/nut assemblies into slots of two of the
legs with the nuts on the bottom (Figure 22.3 and 22.4).
Legs with leveling bolts need to be on opposite
NOTE:
sides of the appliance - one in the front and one in the
back (Figure 22.1)
10. Use Allen wrench to adjust legs up and down to desired
level (Figure 22.5).
3
2
Figure 22.1
22
CAUTION
5
6
4
CHECK BAFFLE BOARDS & CERAMIC BLANKET!
• Verify that the baffle boards and ceramic blanket are
in their proper locations.
• It is important that the baffle boards and ceramic
blanket are correctly installed for proper burn safety.
Figure 22.2
Figure 22.3
9
Figure 22.5
7037-806A
CAUTION
Figure 22.4
05/21

Advertisement

Table of Contents
loading

Table of Contents