Defrosting; Filling The Water Tank - Siemens CS656GB.1B Instruction Manual

Steam
en
Finishing
Touch the On/Off button to switch off the appliance.

Defrosting

Use the "Defrosting ?" type of heating to defrost frozen
products.
If the water tank runs dry during the operation
Note:
with the Defrosting setting, the operation is interrupted.
Fill the water tank.
Starting
Fill the water tank.
1.
Touch the Menu field.
2.
Touch the "Steaming" field.
3.
Use the rotary selector to set to "Defrosting ?".
4.
Touch the "Temperature" field and set the
5.
temperature using the rotary selector.
Touch the "Duration" field and set the duration using
6.
the rotary selector.
Press the Start/Stop button to start.
7.
The appliance heats up. Once the appliance has
heated up, an audible signal sounds and the
operation begins.
Once the duration has elapsed, an audible signal
sounds. The appliance stops heating. The duration 00
m 00 s is shown in the display.
Cancelling
Touch the Start/Stop button to cancel the operation.
Finishing
Touch the On/Off button to switch off the appliance.

Filling the water tank

The water tank is located behind the control panel.
Before starting an operation with steam, open the
control panel and fill the water tank with water.
Make sure that you have set the water hardness range
correctly. ~ "Basic settings" on page 22
:
Warning – Risk of injury and risk of fire!
Only fill the water tank with water or with the descaling
solution that is recommended by us. Do not pour any
flammable liquids (e.g. alcoholic drinks) into the water
tank. Due to hot surfaces, vapours from flammable
liquids may catch fire in the cooking compartment
(explosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
:
Warning – Risk of burns!
The water tank may heat up while the appliance is in
operation. Wait until the water tank has cooled down
after the previous appliance operation. Remove the
water tank from the water tank recess.
18
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Touch the X field.
1.
The control panel is automatically pushed forwards.
Pull the control panel forwards with both hands and
2.
then push it upwards until it locks into place (Fig.
Lift the water tank and remove it from the water tank
3.
recess (Fig. ).
"
Press down on the lid along the seal to prevent
4.
water from leaking out of the water tank.
Remove the cover ‚ (Fig.
5.
Fill the water tank with cold water up to the "max."
6.
mark (Fig. ).
$
Reinsert the cover ‚ into the opening in the water
7.
tank.
Insert the filled water tank (Fig.
8.
water tank locks into place behind both holders ƒ
(Fig. ).
&
Slowly push the control panel downwards and then
9.
towards the rear until it is closed completely.
The water tank has been filled. You can start
operations with steam.
).
#
). Ensure that the
%
).
!