Replacing Bulbs - MG MG6 Owner's Handbook Manual

EMERGENCY INFORMATION

Replacing Bulbs

Before replacing any bulb, switch off the ignition switch and
turn off the lighting switch to avoid any possibility of a short
circuit.
Note: Only replace bulbs with the same type and
specification.
Bulbs may shatter in use if the glass has been scratched,
or contaminated with oil or perspiration. Take care NOT
to touch the glass with your fingers; always use a cloth
to handle the bulb. If necessary, clean the glass with
methylated spirits to remove fingerprints.
For other bulbs that are not listed, please seek the
assistance of a workshop when they need to be replaced.
180
Front Courtesy & Map Reading Lamp
1 Use a small flat-bladed screwdriver to gently prise the
lens from the light unit.
2 Pull the bulbs from their mountings to remove.
Replacement of the bulb is a reversal of the removal
process. When replacing the lens, locate the two prongs
at the front of the lens and then carefully flex the lens to
locate the two prongs at the rear of the lens into the light
unit. Push the lens upwards until it 'clicks' into position.