MG MG6 Owner's Handbook Manual page 183

The model range mg6
Table of Contents

Advertisement

EMERGENCY INFORMATION
remove the compressor plug from the cigarette lighter,
return the tyre repair kit to its stowage tray.
8 After successfully adding sealant to the tyre, drive
immediately for a short time (around one minute) this
will allow the sealant to distribute evenly inside the
tyre. Continue driving and do not exceed 50 MPH
(80 km/h).After a futher ten minutes, find a safe place
to stop and recheck the tyre pressure. If the tyre
pressure has dropped to less than 0.8 bar (11.6 psi),
do not continue driving, seek assistance instead. If
the pressure is greater than 0.8 bar (11.6 psi) after a
10 minutes drive, continue pumping air into type until
reaching the specified tyre pressure and then continue
driving. If 1.8 bar (26.1 psi) cannot be reached, do
not continue drive, seed assistance instead. Do not
exceed 50MPH (80KPH).
Note:
DO NOT remove foreign objects (eg.
screws,nails) from the tyre.
At the earliest opportunity get the tyre replaced by
a dealer or tyre specialist and replace the used tyre
sealant bottle with an MG approved sealant. (Figure
11,12)
168

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents