MG MG6 Owner's Handbook Manual page 45

INSTRUMENTS AND CONTROLS
Stability Control System / Traction Control Off
Warning - Yellow
The light illuminates yellow as a lamp check when the
ignition is in position Ⅱ and extinguishes after a few
seconds. If the stability control system or traction control
system are switched off, the warning light will illuminate.
Stability Control Off
The message
Control Off
will appear in the message centre.
ABS Warning - Yellow
ABS
The light illuminates for a few seconds as a lamp and system
check when the ignition is in position Ⅱ. If the light does not
ABS Fail
extinguish, and appears in the message centre,
then a fault has occurred with the ABS system and you
should seek an MG Authorised Repairer at the earliest
opportunity.
30
If an ABS fault occurs while driving, ABS operation will be
suspended, but normal braking will still be available. Seek
an MG Authorised Repairer at the earliest opportunity.
Brake System Warning - Red
This red warning light will illuminate for a few seconds as a
lamp check when the ignition is in position Ⅱ.
Traction
or
If the warning light remains illuminated after lamp check,
a fault with the brake system is indicated - the message
Brake Fail
brake fluid level (See 'Brake Fluid' in 'Maintenance'). If the
light continues to illuminate, stop the car as soon as safety
permits and seek an MG Authorised Repairer urgently.
Check Engine/Drive by Wire Warning - Yellow
This warning light is used to indicate an engine operation
fault is detected by the engine management system. The
will appear in the message centre. Check the