MG MG6 Owner's Handbook Manual page 182

1 Remove the sticker on the Tyre Sealant Bottle and
attach it to the steering wheel to remind the driver
not to exceed 50 MPH (80 km/h). (Figure 1)
2 Connect the air hose of the electric compressor to the
tyre sealant bottle. (Figure 2)
3 Fit the Tyre Sealant bottle (Upright) into the slot on the
compressor. Remove the valve dust cap from the flat
tyre and connect the filler hose from the tyre sealant
bottle to the tyre valve. (Figure 3)
4 Ensure that the power switch of the electric air pump
is switched off (i.e., press "O"), then insert the plug
from the compressor into the cigarette lighter. (Figure
4)
Note: To avoid battery discharge,
recommended to keep the vehicle engine running.
5 Switch on the power switch of the electric compressor
(i.e., press "-"), to start pumping sealant into the tyre.
The pressure gauge may briefly reach 6 bar (87 psi),
then the pressure begins to drop. (Figure 6, 7)
EMERGENCY INFORMATION
Note: The tyre sealant bottle will become empty
after approximate 30 seconds.
6 The tyre should reach the specified inflation pressure
within 10 minutes.
reached, switch off the compressor. If the required
pressure cannot be reached within 10 minutes, please
disconnect the compressor, drive the vehicle 10
metres (33 feet) approx forward or backward to
allow the sealant to spread within the tyre. If the
required pressure can still not be reached, the tyre is
severely damaged and you should seek assistance from
the breakdown services.
should you continue your journey with a deflated tyre.
Driving a vehicle with a deflated tyre is extremely
dangerous. (Figure 8)
it is
Note: Consecutive operation of the electric air
pump for more than 10 minutes may result in
damage to the compressor.
7 Remove the tyre sealant bottle from the slot in the
compressor, disconnect the hose from the tyre valve,
After the correct pressure is
Under no circumstances
167
6